Access to Peer.endpoint was previously synchronized by Peer.RWMutex.
This has now moved to Peer.endpoint.Mutex. Peer.SendBuffers() is now the
sole caller of Endpoint.ClearSrc(), which is signaled via a new bool,
Peer.endpoint.clearSrcOnTx. Previous Callers of Endpoint.ClearSrc() now
set this bool, primarily via peer.markEndpointSrcForClearing().
Peer.SetEndpointFromPacket() clears Peer.endpoint.clearSrcOnTx when an
updated conn.Endpoint is stored. This maintains the same event order as
before, i.e. a conn.Endpoint received after peer.endpoint.clearSrcOnTx
is set, but before the next Peer.SendBuffers() call results in the
latest conn.Endpoint source being used for the next packet transmission.
These changes result in throughput improvements for single flow,
parallel (-P n) flow, and bidirectional (--bidir) flow iperf3 TCP/UDP
tests as measured on both Linux and Windows. Latency under load improves
especially for high throughput Linux scenarios. These improvements are
likely realized on all platforms to some degree, as the changes are not
platform-specific.
Co-authored-by: James Tucker <james@tailscale.com>
Signed-off-by: James Tucker <james@tailscale.com>
Signed-off-by: Jordan Whited <jordan@tailscale.com>
Signed-off-by: Jason A. Donenfeld <Jason@zx2c4.com>
We can't have the netlink listener socket, so it's not possible to
support it. Plus, android networking stack complexity makes it a bit
tricky anyway, so best to leave it disabled.
Signed-off-by: Jason A. Donenfeld <Jason@zx2c4.com>
Implement TCP offloading via TSO and GRO for the Linux tun.Device, which
is made possible by virtio extensions in the kernel's TUN driver.
Delete conn.LinuxSocketEndpoint in favor of a collapsed conn.StdNetBind.
conn.StdNetBind makes use of recvmmsg() and sendmmsg() on Linux. All
platforms now fall under conn.StdNetBind, except for Windows, which
remains in conn.WinRingBind, which still needs to be adjusted to handle
multiple packets.
Also refactor sticky sockets support to eventually be applicable on
platforms other than just Linux. However Linux remains the sole platform
that fully implements it for now.
Co-authored-by: James Tucker <james@tailscale.com>
Signed-off-by: James Tucker <james@tailscale.com>
Signed-off-by: Jordan Whited <jordan@tailscale.com>
Signed-off-by: Jason A. Donenfeld <Jason@zx2c4.com>
Use the RTMGRP_IPV4_ROUTE const from x/sys/unix instead of using the
corresponding RTNLGRP_IPV4_ROUTE const to create the multicast groups
mask.
Signed-off-by: Tobias Klauser <tklauser@distanz.ch>
Signed-off-by: Jason A. Donenfeld <Jason@zx2c4.com>
The sticky socket code stays in the device package for now,
as it reaches deeply into the peer list.
This is the first step in an effort to split some code out of
the very busy device package.
Signed-off-by: David Crawshaw <crawshaw@tailscale.com>
